Skip to Main Content
 

Global Search Box

 
 
 

ETD Abstract Container

Abstract Header

Wind Tunnel Testing of a Variable Camber Compliant Wing with a Unique Dual Load Cell Test Fixture

Zientarski, Lauren Ann
http://rave.ohiolink.edu/etdc/view?acc_num=dayton1448893315

Abstract Details

2015, Master of Science (M.S.), University of Dayton, Aerospace Engineering.
This thesis describes the design, setup, and testing of a unique mounting fixture built for the Variable Camber Compliant Wing developed by the U.S. Air Force Research Laboratory. The intent of the Variable Camber Compliant Wing is to demonstrate an active 2D section camber change under aerodynamic load. Mounting possibilities were limited in the Vertical Wind Tunnel due to the dimensions and weight of the wing which necessitated a custom design to obtain aerodynamic force measurements. ATI Industrial Automation offers a promising solution with their wide range of multi-axis force/torque sensors which are becoming widely adopted in aerodynamic testing of small unmanned aircraft. These sensors can provide accurate results when loaded in close proximity to the balance center. However, it has been reported in literature that measurement error increases dramatically when the balance is loaded off balance center. In this case, a load cell is mounted on each end of the unique fixture, forming a direct interaction between the two load cells. An extensive calibration loading procedure was performed prior to the test to develop a calibration matrix sensitive to the test setup. The intent of this thesis is to present development of a correction method for this unique mounting fixture which could provide a new flexible wing testing capability in the Vertical Wind Tunnel Facility at the Air Force Research Laboratory.
Aaron Altman (Advisor)
James Joo (Committee Member)
Ray Kolonay (Committee Member)
90 p.
Aerospace Engineering; Engineering
Variable Camber Compliant Wing; Dual Load Cell; Test Fixture Validation; Calibration Loading

Recommended Citations

Citations

  • Zientarski, L. A. (2015). Wind Tunnel Testing of a Variable Camber Compliant Wing with a Unique Dual Load Cell Test Fixture [Master's thesis, University of Dayton]. OhioLINK Electronic Theses and Dissertations Center. http://rave.ohiolink.edu/etdc/view?acc_num=dayton1448893315

    APA Style (7th edition)

  • Zientarski, Lauren. Wind Tunnel Testing of a Variable Camber Compliant Wing with a Unique Dual Load Cell Test Fixture. 2015. University of Dayton, Master's thesis. OhioLINK Electronic Theses and Dissertations Center, http://rave.ohiolink.edu/etdc/view?acc_num=dayton1448893315.

    MLA Style (8th edition)

  • Zientarski, Lauren. "Wind Tunnel Testing of a Variable Camber Compliant Wing with a Unique Dual Load Cell Test Fixture." Master's thesis, University of Dayton, 2015. http://rave.ohiolink.edu/etdc/view?acc_num=dayton1448893315

    Chicago Manual of Style (17th edition)

dayton1448893315
2,497
© 2015, all rights reserved.
This open access ETD is published by University of Dayton and OhioLINK.