Skip to Main Content
 

Global Search Box

 
 
 
 

Files

File List


ThesisDoc_Dalvir.pdf (2.26 MB)

ETD Abstract Container

Abstract Header

Gallium Nitride: Analysis of Physical Properties and Performance in High-Frequency Power Electronic Circuits

Saini, Dalvir K.
http://rave.ohiolink.edu/etdc/view?acc_num=wright1438013888

Abstract Details

2015, Master of Science in Electrical Engineering (MSEE), Wright State University, Electrical Engineering.
Gallium nitride (GaN) technology is being adopted in a variety of power electronic applications due to their high efficiencies even at high switching speeds. In comparison with the silicon (Si) transistors, the GaN-based devices exhibit lower on-state resistance and parasitic capacitances. The thermal performance of the GaN transistors are also better than the Si counterparts due to their higher junction temperature and lower temperature-coefficient of on-resistance. These unique properties make the gallium-nitride power transistors an appropriate selection for power electronic converters and radio-frequency power amplifiers, where size, efficiency, power density, and dynamic performance are major requirements. Foreseeing the immense capabilities of the GaN transistors in the near future for the fast-growing electronic industry, this thesis endeavors to make the following contributions: (a) analyze the important properties of GaN as a semiconductor material, (b) study the formation of the 2-dimensional electron gas layer required for current conduction, (c) determine the functionality of the GaN as a field-effect transistor, and (d) test its performance through simulations and experiments at high switching frequencies in power electronic converters, where the Si-based transistors cease to operate normally. The critical material properties include the intrinsic carrier concentration, the specific on-resistance, and the intrinsic carrier mobility. The dependence of these properties on the temperature is investigated. The comparison of these properties are made with the silicon and silicon-carbide (SiC) semiconductor materials to give a clear view about the superior performance of GaN over the other types. While the Si MOSFETs create a channel to conduct the electrons and holes between the source and drain terminals, the GaN field-effect transistors (FET) form a 2-dimensional electron gas (2-DEG) layer, whose thickness is controlled by the applied gate potential. Because of the high electron density in the 2-DEG layer, the GaN FETs are termed as high-electron mobility transistors (HEMT). The operation of both enhancement and depletion mode GaN FETs are discussed in detail and the model of the drain current through the 2-DEG layer is provided. The figure-of-merit (FOM) for the GaN transistors is explained and then compared with that of Si and SiC transistors. Two important implementations of GaN transistors are in the (a) pulse-width modulated synchronous-buck DC-DC power converters and (b) Class-D resonant inverters. These circuits are better representative examples since they comprise of one GaN FET (high-side switch) connected to a "hot" point and the other GaN FET (low-side switch) referenced to ground. While the low-side switch consumes minimum gate-drive power for turn ON/OFF transitions, the high-side switch demands a higher gate-drive power to operate the transistor as a switch. Also, these switches exhibit switching losses due to the charge/discharge process of the parasitic capacitances. The gate-drive power and switching losses increase as the switching frequency is increased. However, due to the superior performance and very low values of the device parasitic resistances and capacitances in the GaN transistors, higher switching frequencies can be achieved at very minimal switching losses. Simulations were performed to analyze the behavior of the two circuits at different switching frequencies and were compared with those using Si transistors. It is observed that the overall efficiency reduced to 48% at 5 MHz for the Si-based buck converter and down to 41% at 5 MHz for the Si-based Class-D inverter. However, using GaN transistors showed an improved performance, where the overall efficiency reduced to only 71% at 15 MHz for the buck converter and 60% at 10 MHz for the Class-D inverter. Further, experimental validations were performed on a prototype of the synchronous buck converter developed using the high-frequency, half-bridge switching network module EPC9037 manufactured by Efficient Power Conversion Corporation. The module comprises of the enhancement-mode GaN transistors and a high-speed, dual-side, high-performance gate-driver LM5113 by Texas Instruments. The experimental results showed the immense capability of the GaN transistors to achieve high efficiencies. The experimentally measured efficiency of the synchronous buck converter was 85% at a switching frequency of 5 MHz and reduced to 60% at 8MHz. The theoretical predictions were in good agreement with simulation and experiment results.
Marian Kazimierczuk, Ph.D. (Advisor)
Ray Siferd, Ph.D. (Committee Member)
Saiyu Ren, Ph.D. (Committee Member)
144 p.
Electrical Engineering
Gallium nitride; GaN; silicon carbide; high frequency power converters; semiconductors; Efficient Power Conversion; power losses; high-efficiency; switching losses; field-effect transistors; synchronous buck dc-dc converter; class-D resonant inverter

Recommended Citations

Citations

  • Saini, D. K. (2015). Gallium Nitride: Analysis of Physical Properties and Performance in High-Frequency Power Electronic Circuits [Master's thesis, Wright State University]. OhioLINK Electronic Theses and Dissertations Center. http://rave.ohiolink.edu/etdc/view?acc_num=wright1438013888

    APA Style (7th edition)

  • Saini, Dalvir. Gallium Nitride: Analysis of Physical Properties and Performance in High-Frequency Power Electronic Circuits. 2015. Wright State University, Master's thesis. OhioLINK Electronic Theses and Dissertations Center, http://rave.ohiolink.edu/etdc/view?acc_num=wright1438013888.

    MLA Style (8th edition)

  • Saini, Dalvir. "Gallium Nitride: Analysis of Physical Properties and Performance in High-Frequency Power Electronic Circuits." Master's thesis, Wright State University, 2015. http://rave.ohiolink.edu/etdc/view?acc_num=wright1438013888

    Chicago Manual of Style (17th edition)

wright1438013888
3,049
© 2015, all rights reserved.
This open access ETD is published by Wright State University and OhioLINK.